SPS Inverter - Mini Emergency Power System

SPS

The SPS inverter system is designed to provide 220/250VA of emergency power to incandescent, fluorescent, induction and/or LED fixtures. The SPS unit provides clean, sinusoidal AC output power allowing it to be remotely mounted up to 1,000 feet away from the controlled fixture(s). Unlike a ballast fluorescent emergency pack, the SPS provides power to the input side of the fixture (including the ballast) eliminating any chance of incompatibility. The SPS is designed primarily for surface mounting; however, the SPS-55/125 and SPS-110/125 models provide optional housings for recessed or ceiling T-Grid mounting if required. All SPS systems will provide emergency power output for a minimum of 90 minutes.

  • Sinusoidal output eliminates compatibility problems
  • Universal 120/277VAC, 60Hz input/output
  • Unit capactities of 220W/250VA
  • “Soft Start” design reduces fixture inrush current
  • Unit may be installed up to 1,000 feet from controlled fixture(s)
  • Lumen output from fixture is 100% of nominal
  • Unique design eliminates compatibility problems with LED drivers as well as fluorescent ballasts
  • Compatible with dimming ballasts
  • Surface, recessed, or T-Grid mountable
  • Normally-ON and/or Normally-OFF load output
  • Provisions for local switching capability - always on during emergency conditions regardless of local switch position
  • Emergency fixtures can be ON, OFF, or SWITCHED
  • Solid-state line latched low voltage disconnect provides protection against battery deep discharge
  • Momentary test switch,
  • AC-ON, Charge-ON, and Inverter-ON LED indicators
LED
Spec Sheet
Photometrics

MOBERN LIGHTING COMPANY

8200 Stayton Dr., Ste. 500

Jessup, Maryland 20794

Phone: 800.444.9288

Fax: 301.953.9310

Email: sales@mobern.com

FOLLOW US