MPS - Emergency Micro Power System

The MPS is designed to provide 20W to 55W of emergency power to incandescent, fluorescent, induction and/or LED fixtures. The MPS unit provides clean, sinusoidal AC output power allowing it to be remotely mounted up to 1,000 feet away from the controlled fixture(s). Unlike a ballast fluorescent emergency pack, the MPS provides power to the input side of the fixture (including the ballast) eliminating any chance of incompatibility. The MPS is designed for surface mounting, and all systems will provide emergency power output for a minimum of 90 minutes.

  • True sinusoidal AC pulse width modulated (PWM) design provides clean 60Hz emergency output
  • Universal 120/277VAC, 60Hz input/output s Unit capactities of 20W to 55W
  • “Soft Start” design reduces fixture inrush current
  • Unit may be installed up to 1,000 feet from controlled fixture(s)
  • Lumen output from fixture is 100% of nominal
  • Unique design eliminates compatibility problems with LED drivers as well as fluorescent ballasts
  • Surface, recessed, or T-Grid mountable s Normally-ON and/or Normally-OFF load output
  • Provisions for local switching capability - always on during emergency conditions regardless of local switch position
  • Temperature compensated, dual-mode charger includes low voltage disconnect feature to provide protection against battery deep discharge
  • Solid-state line latched low voltage disconnect provides protection against battery deep discharge
  • Maintenance-free, lead-calcium, and premium grade nickel cadmium battery models offered
  • Control panel with momentary test switch, AC-ON, Charge-ON, and Inverter-ON LED indicators
  • Battery circuit fuse protected s Reverse battery and AC lockout protection
Spec Sheet


8200 Stayton Dr., Ste. 500

Jessup, Maryland 20794

Phone: 800.444.9288

Fax: 301.953.9310