LPS - Large Emergency Power System

The LPS is designed to provide 375 to 600 watts of emergency power to incandescent, fluorescent, induction and/or LED fixtures. The LPS unit provides clean, sinusoidal AC output power allowing it to be remotely mounted up to 1,000 feet away from the controlled fixture(s). Unlike a ballast fluorescent emergency pack, the LPS provides power to the input side of the fixture (including the ballast) eliminating any chance of incompatibility. The LPS is designed for surface mounting, and all systems will provide emergency power output for a minimum of 90 minutes

  • Sinusoidal output eliminates compatibility problems
  • Universal 120/277VAC, 60Hz input/output
  • Unit capactities up to 600 watts
  • “Soft Start” design reduces fixture inrush current
  • Unit may be installed up to 1,000 feet from controlled fixture(s)
  • Lumen output from fixture is 100% of nominal
  • Unique design eliminates compatibility problems with LED drivers as well as fluorescent and induction ballasts
  • Compatible with dimming ballasts
  • Normally-ON and/or Normally-OFF load output
  • Provisions for local switching capability - always on during emergency conditions regardless of local switch position
  • Emergency fixtures can be ON, OFF, or SWITCHED
  • Solid-state line latched low voltage disconnect provides protection against battery deep discharge
  • Long-life, maintenance-free, lead-calcium battery
  • Momentary test switch s AC-ON, Charge-ON, and Inverter-ON LED indicators
Spec Sheet


8200 Stayton Dr., Ste. 500

Jessup, Maryland 20794

Phone: 800.444.9288

Fax: 301.953.9310

Email: sales@mobern.com